** This job is being posted across two skill levels (Associate / Level I) and (Staff / Level II). Applicants will be considered for the higher of the levels in which they qualify. **
Acts as a company subject matter expert for substation power equipment, providing technical expertise and support for the evaluation, acceptance testing, commissioning, maintenance, and operation of substation power equipment.
LEVEL OF RESPONSIBILITY
General responsibilities with standardized processes. Works under limited supervision. Resolves routine questions and problems. Refers the more complex issues to higher levels. Follows established procedures to accomplish requirements of job. Some latitude for deviation.
ESSENTIAL FUNCTIONS
- Develop equipment specifications, perform factory inspection and certification, and support equipment factory acceptance testing (FAT)
- Developing power equipment test plans and procedures and review equipment test results to support power equipment commissioning, operations, and maintenance
- Provide on-site and remote support to field personnel during routine maintenance, troubleshooting, and equipment repairs. Lead and perform root cause analysis of failed in service equipment and misoperations.
- Ensures the safe operation of power equipment by acting as the subject matter expert to interpret power equipment test results and recommend corrective actions.
- Develops technical procedures and guidelines used by Substation Operations, Power Equipment Service Center, and contractors
- Represents the Company interests and develops influence within the industry by participating in standards development, regulatory, and manufacturer working groups
- Works with power equipment manufacturers to identify issues and develop technical solutions related to equipment failures, defects, and operational concerns
- Supports the installation and development of substation monitoring equipment
REQUIREMENTS
ASSOCIATE / Level I
Bachelor's Degree in Engineering or PE
STAFF / Level II
Bachelor's Degree in Engineering or PE, And 2 years related engineering experience (which may include non-Engineer experience such as Engineering Internship, Design, Drafting, and Engineering Tech experience. This type of experience will be counted at half rate.)
PREFERRED QUALIFICATIONS
- Knowledge of or experience with factory acceptance testing equipment (transformers, breakers, etc.).
- Knowledge of or experience with in-service and off-line diagnostic testing of substation power equipment to assess equipment health.
- Knowledge of or experience with Dissolved Gas Analysis (DGA), Sweep Frequency Analysis (SFRA), and Partial Discharge (PD) testing.
OG&E
321 N Harvey
Oklahoma City
Oklahoma United States
www.oge.com
